Photo: Haskel nose low and inverted in a P-51, from Eddie's collection.
If you've never practiced upset recovery in a high performance aircraft, you may not be prepared for the shock of hanging from your straps and you may not instinctively know how to unload the aircraft to safely recover. So you need to train in an airplane, the simulator is not good enough. The quality of training varies and in some cases what is being taught can kill. So let's get this out of the way first: unless you are in a dog fight, the only time you need rudder in most jet aircraft is during takeoff, landing, or when dealing with an asymmetric engine failure. There is a company in Texas that preaches: "push, power, rudder, roll." Don't give them a dime, they don't know what they are talking about.
No doubt about it, you need to know this stuff for when you least expect it. And you need to know how to do it right the first time.
There are several high quality unusual attitude recovery courses out there. The accompanying photos are from my experiences with Unusual Attitude Training, based in Kissimmee, Florida, www.JetUAT.com. They are experts.
What follows comes from the references shown below and my comments shown in blue.
The key to getting it right the first time is to understand where things can go horribly wrong and understanding how to best make the airplane get back to right side up. Properly executed, each step of the process makes the next step easier. While acronyms sometimes serve more to confuse than clarify, you might consider this: RUTAP
Figure: Verify the unusual attitude, from AFM 51-37, figure 2-9.
We used to have the student close his or her eyes, smoothly invert the airplane, cage the attitude indicator, flip the airplane right-side-up, and say "recover." Ah such fun. But in those days it was common to have an attitude indicator lie to you. These days some attitude indicators have no moving parts at all and a mean-time-between-failures measured in years. Still, you could have an instrument lie to you and you should verify that an unusual attitude actually exists.
Figure: Bank attitude interpretation, from AFM 51-37, figure 9-2.
From what used to be the holy grail of all Air Force instrument pilots:
[AFM 51-37, ¶2-8.]
Warning: It is imperative to immediately transition to instrument references any time you become disoriented or when outside visual references become unreliable.
So how do you do this? Crosscheck!
Photo: Haskel nose high and unloaded in an L-39, from Eddie's collection.
Once you've recognized the upset, the first thing you should do is disengage the autopilot, which could very well be the cause of the situation in the first place. Next, the best thing you can do in all but one situation is unload the airplane. In plain English, you need to push forward on the yoke or stick to put the wing as close to 0-G as possible. The only exception is when the upset leaves the airplane mostly right side up and pulling gains you immediate altitude when close to the ground.
The first and immediate benefit to unloading is removing the threat of an aerodynamic stall, which will send the airplane downward and risks a spin. Not all aircraft pitch down when stalled, some T-tailed, swept wing aircraft actually pitch up. Pitch up or down, a stall makes upset recovery more difficult and must be avoided.
The second benefit of unloading the wing is the aircraft's roll rate improves dramatically. You will lose less altitude when recovering an inverted, nose-low airplane by pushing to near 0-G, rolling crisply to right side up, and then pulling to level flight. This holds true even when significantly nose low. Where a typical business jet can take 5 seconds or more to roll upright with 1-G or more on the wing, the roll can be completed in 1 or 2 seconds when closer to 0-G.
Figure: Critical Mach, from Eddie's notebook.
There are two problems with thrust in an unusual attitude: not having enough and having too much:
Novice pilots are quick to grab a handful of throttles in an attempt to fix things as quickly as possible, but can make things worse if their initial reaction is wrong. Consider two alternate strategies when it comes to power lever management.
Of course aircraft with speed brakes have another arrow in the quiver that can help in a nose-low situation. But grabbing the speed brake handle at the wrong moment can turn a moderate nose-high situation into a severe nose-low upset. Consider leaving the boards alone unless the nose is very low and the airspeed indicator and the "barber pole" are merging into a single pointer.
Photo: Haskel slicing the horizon with an L-39, from Eddie's collection.
Notice that at 0.3 G the aircraft flies just fine below 1-G stall speed (the red line on the speed tape)
[AFM 51-37, ¶2-8.]
Waiting until step four to roll the aircraft has two benefits that some pilots may not have considered. It gives you a second to decide which direction you need to roll and unloading the wing makes the roll faster. Note that the roll is handled with ailerons only. Fighter pilots have long known the danger of "rolling G's" but the risk of damage is even higher in an airplane not designed for combat maneuvering. VA, maneuvering speed, does not consider any rudder input at all and loading the wing with any kind of yaw risks losing airplane parts.
In a nose-high recovery simply pushing forward with wings level takes time and risks running into negative G limits or sending unsecured objects in the cabin flying. You need to increase bank to help the nose fall to the horizon. In a nose-low recovery, there are various methods for recognizing which direction to roll, such as "roll to blue" or "roll to the sky pointer." These are aircraft dependent and pilots must know how their attitude systems will react to an unusual attitude. Once you've determined where the sky is, roll in the shortest direction to level the wings.
Photo: Haskel at the bottom of a loop in an L-39, from Eddie's collection.
[AFM 51-37, ¶2-8.]
The last step in the nose-low recovery process happens only once the airplane is upright. If imminent ground contact is not a threat, keeping within the aircraft's G-limits will not only make the recovery possible, but will keep the airplane flyable once recovered.
In a nose-high recovery you are in a race with time to get the aircraft's attitude under control before you run out of airspeed. How far do you roll to help the nose fall back to the horizon? Most upset courses use small, nimble fighter aircraft that can "knife-edge" beautifully. Rolling to 90° of bank and holding close to zero-G allows the nose to fall back to the horizon quickly and removes the threat of a stall. A quick snap of the wrist returns the airplane to level flight. That may not be true with your aircraft. A typical Gulfstream, for example, is quite a bit heavier and rolls much more slowly than a P-51 Mustang. If you allow the Gulfstream to knife-edge to the horizon, the momentum of the falling nose may put you into nose-low upset by the time you roll wings level. For these aircraft, rolling to 60° of bank may get the nose down expeditiously while allowing the pilot enough time to judge the roll out.
Anytime the nose is above the horizon the chance of an aerodynamic stall is increased. But just because you are below the stall speed listed in your flight manual, doesn't mean you will be in a stall.
Pilots are taught early the dangers of aerodynamic stall and the need to keep air flowing over the wing. Most understand there is a magic airspeed above which "airplane happy" and below which "airplane unhappy." While that knowledge may be good enough for an introductory flight lesson, it misses an important point. An airfoil does not stall at a magic airspeed, it stalls at a particular angle of attack. Yes the speed changes with altitude and aircraft weight. But it also changes with G-loading. The best way to figure when an airplane really stalls is by looking at its operating envelope.
An aircraft's operating envelope is plotted on a V-G diagram, so called because it plots airspeed (V) against load factor (G). There is a unique V-G diagram for every combination of gross weight, configuration, and altitude. The construction of a V-G diagram is detailed in 14 CFR 25.333 but manufacturers are not required to provide pilots with this information. That is too bad, because V-G diagrams speak volumes on how to keep an airplane flying. You can construct your own using 25.333, your aircraft manual's limitations and stall performance numbers. (I walk you through the process: Basic Aerodynamics / Operating Flight Strength (V-g / V-n Diagrams).
Fortunately, you need only see an example of a similar aircraft's V-G diagram to learn the necessary lessons. A Gulfstream 450 behaves conventionally, tolerating between -1 and 2.5 G's when in the clean configuration, and makes for a good example passenger carrying aircraft.
Graph: G450 V-g diagram, sample conditions, from Eddie's notes.
Looking at the example V-G Diagram for a sample aircraft, we see the red area depicts where we can exceed airspeed and G-limits, risking damage to the airplane. The orange area illustrates where we risk aerodynamic stall. What remains – the cyan, blue, and green – is the aircraft's operating envelope. The airplane is flyable anywhere in this region. But we normally limit ourselves to the green zone, where we are flying faster than the aerodynamic stall, slower than maximum operating speed, and between 1G and the airplane's maximum load factor. We choose not to operate in the negative-G zone, the cyan, because we don't want our passengers or any unsecured objects in the cabin flying about. That leaves us with the blue area, where we are at less than 1-G but more than 0-G. We as pilots try very hard to stay out of that zone too, because it can be uncomfortable and risks scaring our passengers. But we should become familiar with it, especially just above 0-G, because it can save you following an aircraft upset.
Notice that our aircraft has a 1-G stall speed of 130 knots under the sample conditions. Let's say an upset leaves the nose very high and your airspeed is 200 and heading south fast. After you've rolled the aircraft and the nose is falling nicely you find the speed approaching 130 knots. Reducing the load factor to 0.5-G reduces your stall speed to 92 knots. That half-a-G bought you nearly 40 knots of airspeed.
So we can agree that unloading the aircraft to less than 1-G gains you a faster roll rate and greater stall margin. We also realize going to less than 0-G risks passenger injuries from flying objects and people in the cabin. But how do we know we are unloading enough and not too much? As good as current simulator technology is, you cannot simulate sustained G forces. There is no substitute for actual flight experience, hanging from the straps to know what negative G's feel like, or just light in the pants to judge a fraction of a G.
Feeling sustained negative G forces not only gives pilots an experience-based seat of the pants barometer for unloading a wing, it also prepares them to overcome what can paralyze pilots without that training. . .
Photo: Haskel looking at nothing but ground in a P-51, from Eddie's collection.
Highly experienced pilots who have never been inverted or felt 0-G in a jet for more than a second or two can be prone to air sickness and an inability to complete memorized recovery tasks. Pilots with Air Force or Navy training tend to react properly, even decades after their "yanking and banking" days. The difference is the military pilots were subjected to desensitization that made upside-down just another phase of flight.
Pilots are normally trained to fly in the middle of the air and told to avoid the edges. (The edges are the ground, water, buildings, and extraterrestrial space.) Because you never truly risk death in a simulator, you are not properly trained for dealing with an aircraft upset until you've been trained in a high performance airplane. There is risk in flying any airplane and when that airplane is pointed to the edge, every pilot's inner warning and caution system turns from amber to red. Every time you deal with that inner warning system, you get better at it. So practice in an airplane in a controlled environment before it happens when you least expect it.
I was first trained to handle jet upsets in 1979 flying a T-37 and later a T-38. Thirty-five years later I found the lessons remained in my muscle memory . . .
L-39 Nose High Recovery — (From Upset Training in 2015)
L-39 Nose Low Recovery — (From Upset Training in 2015)
P-51 Nose High Recovery — (From Upset Training in 2015)
The recognition step in some high tech cockpits can have a few traps. In the G450, for example, the back up instruments do not represent what you might think. The standby instrument you would think is a good tie breaker for heading information simply parrots the pilot's instruments.
[G450 Aircraft Operating Manual, ¶2B-05-50, pg. 65] The pilot’s side defaults to IRS1, ADS1, and RAD ALT1 selected. The copilot’s side defaults to IRS2, ADS2, and RAD ALT2 selected.
[G450 Aircraft Operating Manual, ¶2A-34-30 ¶2.] The SFD display presents a standard Primary Flight Display (PFD) format with an airspeed tape and digital airspeed readout on the left and an altitude tape and digital altitude readout on the right. The SFD contains an independent internal reference system for attitude data, a stand-alone magnetic heading reference from a vertical stabilizer mounted magnetometer, and airspeed and altitude data derived from the dedicated connections to pitot/static system.
[G450 Aircraft Operating Manual, ¶2A-34-30 ¶3.] The Electronic Bearing and Distance Indicator (EBDI) incorporates a standard compass card with airplane symbol, two bearing pointer needles, two range / DME indicators and a digital heading indicator with heading reference notation. . . . [In the AUTO position] - automatically selects heading source with a priority of IRS #1, IRS #2, or STBY.
When looking for an independent indication of aircraft attitude, heading, altitude, and airspeed, the SFD is your go to location. The EBDI defaults to IRS #1 and is not a valid tie breaker unless you switch it to STBY.
[G450 Aircraft Operating Manual, ¶06-03-50]
Increase power and angle of bank, not to exceed 90° in the same direction as the turn. As the nose of the aircraft falls below the horizon, decrease bank to wings level and nose on the horizon. This type of recovery will avoid negative G-Forces.
Smoothly reduce power, leveling the wings, easing the nose up to the horizon. Use the speed brakes to assist in reducing the speed if required.
My technique is to leave the power levers alone and let the autothrottles do the thinking for me. They have a better track record than I do in these situations. In the simulator this has always worked.
Portions of this page can be found in the book Flight Lessons 1: Basic Flight, Chapter 9.
Air Force Manual (AFM) 51-37, Instrument Flying, 1 December 1976
Gulfstream G450 Aircraft Operating Manual, Revision 35, April 30, 2013.